Table of Contents
Advertisement
Setting the Interfaces
Using Smart Test
3 With Smartsetup highlighted, press
START
to auto-discov
information about
er
the receive signal. Or press
to exit Smart Test.
CANCEL
An example of a typical display after choosing to RUN Smartsetup is shown below.
Note: The channel information displayed is the one obtained the last time a SCAN
was performed (see Figure 1). If you have changed the input signal since the last
Smartsetup you must perform a RESCAN now. If you have selected a PDH/DSn
interface and a PDH/DSn signal is received, a tributary mapping display indicating
the framing and status of each tributary is given, (see Figure 2).
Figure 1
42
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
