Agilent Technologies OmniBER 718 SDH User Manual page 147

Making Measurements
Measuring Jitter Transfer
12 With MODE set to
The Jitter Transfer display is replaced by an information display for the duration
of the Calibration.
A bar graph showing the progress of the calibration will appear on the display.
When the Calibration is complete, the display will revert to the
HOW TO: Start the Jitter Transfer Measurement
N O T E The Jitter Transfer measurement must be started within 10 minutes of the completion
of calibration.
1 After the CALIBRATION is completed, remove the back to back connection
from the PDH or SDH or optical interfaces.
If the measurement is to be made at a network equipment monitor point, choose
the jitter transfer measurement.
2 Choose MODE
The measurement's progress can be monitored on the
HOW TO: View the Results
1
Select
FORMAT.
146
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CALIB
display.
JITTER
on the PDH
MONITOR
RECEIVE
MEASURE
.
RUN/STOP
and
, JITTER
RESULTS
press to start the calibration.
RUN/STOP
display before making
MAIN SETTINGS
on the
JITTER
TRANSMIT
TRANSMIT
, then choose the results
TRANSFER FN
TRANSMIT
display and press
display.