Table of Contents
Advertisement
Making Measurements
Measuring Pointer Adjustment (Tributary) Jitter
9 Select
and a period of 20 seconds.
10 Set the jitter measurement range to 1.6 UI and measurement filter to LP+HP1, as
shown below.
11 Press
12 Verify that no alarms or errors are detected by the OmniBER receiver.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
,
TIMING CONTROL
RESULTS
to start the
measurement.
RUN/STOP
and set TEST TIMING to
SINGLE
151
Advertisement
Table of Contents
