Table of Contents
Advertisement
Tandem Connection Monitoring
Tandem Connection Terminating Equipment (TCTE) Testing
Error Monitoring
Method: Use the OmniBER Transmitter to generate errors in the system under test
Testing
and verify on the Receiver that the correct error result is obtained.
13 Press the
14 Select the
15 Set the TEST FUNCTION field to
16 Select an ERROR ADD TYPE and RATE, for this example we have chosen to
add B3 BIP errors at a rate of 1E-5, as shown below.
17 Press
setting test periods.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
TRANSMIT
key and select
folder.
TEST FUNCTION
to start the test. See "Test Timing" page 111 for advice on
RUN/STOP
SDH
.
and select
SDH
ERRORS & ALARMS
.
239
Advertisement
Table of Contents
