Table of Contents
Advertisement
Packet over SDH (POS)
Setting up the Transmitter for POS Payloads
Setting up the Transmitter for POS Payloads
Description
The transmitter rate and mapping can be set up to match the requirements of the
equipment under test. At SDH, select a rate from STM-0 to STM-16 optical.
CA UTI O N
Laser On/Off selection. Always switch off the laser before connecting or
disconnecting optical cables.
TIP
To set the Transmitter and Receiver to the same interface settings choose
SETTINGS CONTROL COUPLED
the same settings as the transmitter.
How to
1 Press the
2
3 If Option 106, Dual Wavelength optical module, is fitted and an optical rate is
chosen, choose the required wavelength (1550 or 1310).
If STM-0 is chosen, choose the required interface level (CROSS-CONNECT,
HIGH or LOW).
Choose
chosen, see "Setting SDH THRU Mode " page 38.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
TRANSMIT
key and select
Select the SIGNAL rate.
unless
INTERNAL
. This causes the receiver to be configured to
SDH
.
is required. If
THRU MODE
OTHER
is
THRU MODE
185
Advertisement
Table of Contents
