Table of Contents
Advertisement
Connecting to the Network
•
ALWAYS DEACTIVATE THE LASER BEFORE CONNECTING OR
DISCONNECTING OPTICAL CABLES.
•
When connecting or disconnecting optical cables between the module and de-
vice-under-test, observe the connection sequences given below.
Connecting:
Disconnecting:
•
NEVER examine or stare into the open end of a broken, severed, or disconnected
optical cable when it is connected to the module's Optical Out connector.
•
Arrange for service-trained personnel, who are aware of the hazards involved, to
repair optical cables.
CA UTI O N
1. Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
2. Always fit the fibre optic connector dust caps on each connector when not in use.
Before connection is made, always clean the connector ferrule tip with acetone or
alcohol and a cotton swab. Dry the connector with compressed air. Failure to
maintain cleanliness of connectors is liable to cause excessive insertion loss.
Laser Warning Symbols
The front panel of the optical module has the following label:
CLASS 1 LASER PRODUCT
N O T E
CLASS 1 LASER PRODUCT translates as follows:
Finnish - LUOKAN 1 LASERLAITE
Finnish/Swedish - KLASS 1 LASER APPARAT
This label indicates that the radiant energy present in this instrument is non-
hazardous.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Connect the optical cable to the input of the device-under-test
before connecting to the module's Optical Out connector.
Disconnect the optical cable from the module's Optical Out
connector before disconnecting from the device-under-test.
Always fit the fibre optic connector dust caps over the laser
aperture.
17
Advertisement
Table of Contents
