Table of Contents
Advertisement
Connecting to the Network
Connecting to the Network
The network connectors are located on the modules at the side of the instrument.
The connections available depend on the options fitted to your instrument.
Before connecting, note the Warning and Caution information given.
All Connectors
CA UTI O N
When connecting or disconnecting, ensure that you are grounded or,
make contact with the metal surface of the Mainframe with your free hand to bring
you, the module, and the mainframe to the same static potential.
Modules remain susceptible to ESD damage while the module is installed in the
Mainframe
Additional ESD information is required when servicing, see your Installation/
Verification manual for further information.
Optical Interface Connectors
For your protection, review all laser information given in this manual and the
Verification manual before installing or using the instrument.
WA RN IN G
To prevent personal injury, avoid use that may be hazardous to others, and
maintain the module in a safe condition Ensure the information given below is
reviewed before operating the module.
Laser Product Classification
All optical modules are classified as Class I (non-hazardous) laser product in the
USA which complies with the United States Food and Drug Administration (FDA)
Standard 21 CFR Ch.1 1040.10, and are classified as Class 1 (non-hazardous) laser
products in Europe which complies with EN 60825-1 (1994).
To avoid hazardous exposure to laser radiation, it is recommended that the following
practices are observed during system operation:
16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
