User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP address value to
denote a range of IP addresses from which SNMP clients may use that community to access the
device. A value of 255.255.255.255 will allow access from only one station, and will use that
machine's IP address for the client IP Address. A value of 0.0.0.0 will allow access from any IP
address. The name is the applicable community name.
Default
Format
Mode
no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is the
applicable community name. The community name may be up to 16 alphanumeric characters.
Format
Mode
snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP manager
associated with this community manages the switch according to its access right. If the community
is disabled, no SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed back to
Enable.
Default
Format
Mode
no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no SNMP requests
using this community are accepted. In this case the SNMP manager associated with this
community cannot manage the switch until the Status is changed back to Enable.
Switching Commands
0.0.0.0
snmp-server community ipmask <ipmask> <name>
Global Config
no snmp-server community ipmask <name>
Global Config
The default private and public communities are enabled by default. The
four undefined communities are disabled by default.
snmp-server community mode <name>
Global Config
202-10102-01, May 2005
8-29