No Sntp Unicast Client Poll-Retry; Sntp Multicast Client Poll-Interval; No Sntp Multicast Client Poll-Interval; Sntp Server - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

no sntp unicast client poll-retry

This command will reset the poll retry for SNTP unicast clients to its default value.
Format
Mode

sntp multicast client poll-interval

This command will set the poll interval for SNTP multicast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 16.
Default
Format
Mode

no sntp multicast client poll-interval

This command will reset the poll interval for SNTP multicast clients to its default value.
Format
Mode

sntp server

This command configures an SNTP server (with a maximum of three) where the server address
can be an ip address or a domain name and the address type either ipv4 or dns. The optional
priority can be a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format
Mode

no sntp server

This command deletes an server from the configured SNTP servers.
Format
Mode
Switching Commands
no sntp unicast client poll-retry
Global Config
6
sntp multicast client poll-interval <poll-interval>
Global Config
no sntp multicast client poll-interval
Global Config
sntp server <ipaddress/domain-name> <addresstype>
[<priority> [<version> [<portid>]]]
Global Config
no sntp server remove <ipaddress/domain-name>
Global Config
202-10102-01, May 2005
8-75