Show Classofservice Dot1P-Mapping; Show Classofservice Ip-Precedence-Mapping - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Modes

show classofservice dot1p-mapping

This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the 802.1p mapping table of the
interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format
Mode
The following information is repeated for each user priority.
User Priority
Traffic Class

show classofservice ip-precedence-mapping

This command displays the current IP Precedence mapping to internal traffic classes for a specific
interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the IP Precedence mapping table of
the interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format
Mode
The following information is repeated for each user priority.
IP Precedence
Traffic Class
10-32
Global Config
Interface Config
show classofservice dot1p-mapping [slot/port]
Privileged EXEC
The 802.1p user priority value.
The traffic class internal queue identifier to which the user priority value
is mapped.
show classofservice ip-precedence-mapping [slot/port]
Privileged EXEC
The IP Precedence value.
The traffic class internal queue identifier to which the IP Precedence
value is mapped.
202-10102-01, May 2005
Quality of Service (QoS) Commands