No Dot1X Port-Control All; Dot1X Re-Authenticate; Dot1X Re-Authentication; No Dot1X Re-Authentication - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Mode

no dot1x port-control All

This command sets the authentication mode to be used on all ports to 'auto'.
Format
Mode

dot1x re-authenticate

This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error
will be returned.
Format
Mode

dot1x re-authentication

This command enables re-authentication of the supplicant for the specified port.
Default
Format
Mode

no dot1x re-authentication

This command disables re-authentication of the supplicant for the specified port.
Format
Mode

dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
Default
Security Commands
Global Config
no dot1x port-control all
Global Config
dot1x re-authenticate <slot/port>
Privileged EXEC
disabled
dot1x re-authentication
Interface Config
no dot1x re-authentication
Interface Config
disabled
202-10102-01, May 2005
9-9