Set Garp Timer Join; No Set Garp Timer Join; Set Garp Timer Join All; No Set Garp Timer Join All - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

set garp timer join

This command sets the GVRP join time per port and per GARP. Join time is the interval between
the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership
for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds). the value 20 centiseconds is 0.2 seconds.
Default
Format
Mode

no set garp timer join

This command sets the GVRP join time per port and per GARP to 20 centiseconds (0.2 seconds).
This command has an effect only when GVRP is enabled.
Format
Mode

set garp timer join all

This command sets the GVRP join time for all ports and per GARP. Join time is the interval
between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering)
membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
Format
Mode

no set garp timer join all

This command sets the GVRP join time for all ports and per GARP to 20 centiseconds (0.2
seconds). This command has an effect only when GVRP is enabled.
Format
8-100
20
set garp timer join <10-100>
Interface Config
no set garp timer join
Interface Config
20
set garp timer join all <10-100>
Global Config
no set garp timer join all
202-10102-01, May 2005
Switching Commands