Spanning-Tree Edgeport; No Spanning-Tree Edgeport; Spanning-Tree Forceversion; No Spanning-Tree Forceversion - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Format
Mode

spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal spanning
tree. This will allow this port to transition to Forwarding State without delay.
Format
Mode

no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
Mode

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
• 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
• 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality
supported)
• 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
Format
Mode

no spanning-tree forceversion

This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
Format
Switching Commands
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
no spanning-tree edgeport
Interface Config
802.1s
spanning-tree forceversion <802.1d | 802.1w | 802.1s>
Global Config
no spanning-tree forceversion
202-10102-01, May 2005
8-121