No Users Passwd; Users Snmpv3 Accessmode; No Users Snmpv3 Accessmode; Users Snmpv3 Authentication - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

no users passwd

This command sets the password of an existing operator to blank. When a password is changed, a
prompt will ask for the operator's former password. If none, press enter.
Format
Mode

users snmpv3 accessmode

This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
the specified access mode applies. The default is
other users
Default
Format
Mode
Global Config

no users snmpv3 accessmode

This command sets the snmpv3 access privileges for the specified login user as readwrite for the
'admin' user; readonly for all other users. The <username> is the login user name for which the
specified access mode will apply.
Format
Mode
Global Config

users snmpv3 authentication

This command specifies the authentication protocol to be used for the specified login user. The valid authentication
protocols are none, md5 or sha.
snmpv3 authentication password and therefore must be at least eight characters in length. The
< is the login user name associated with the authentication protocol.
username>
Default
Format
Mode
8-80
no users passwd <username>
Global Config
or
readonly readwrite
admin -- readwrite; other -- readonly
users snmpv3 accessmode <username> <readonly | read-
write>
no users snmpv3 accessmode <username>
If md5 or sha are specified, the user login password is also used as the
no authentication
users snmpv3 authentication <username> <none | md5 |
sha>
Global Config
202-10102-01, May 2005
. The < is the login user name for which
username>
for 'admin' user;
readwrite
for all
readonly
Switching Commands