Show Monitor Session 1; Shutdown - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Note: This is a stand-alone "no" command. This command does not have a "normal" form. This
command can be issued without regard for the session status (enabled or disabled).
Default
Format
Mode

show monitor session 1

This command displays the Port monitoring information for a particular mirroring session.
Note: The <session-id> parameter is an integer value used to identify the session. In the current
version of the software, the <session-id> parameter is always 1.
Format
Mode
The following is the explanation of the output parameters for this command:
Session ID It is an integer value used to identify the session. Its value can be anything
between 1 and L7_MIRRORING_MAX_SESSIONS.
Monitor Session Mode
Probe Port
List of source Ports It is the list of ports, which are configured as mirrored ports (source
ports) for the session identified with <session-id>. If no source port is configured for the session
then this field is blank.

shutdown

This command disables a port.
Default
Format
Mode
8-42
enabled
no monitor session <session-id>
Global config
show monitor session <session-id>
Privileged EXEC
It indicates whether the Port Mirroring feature is enabled or
disabled for the session identified with <session-id>. The
possible values are Enabled and Disabled.
It is the probe port (destination port) for the session identified
with <session-id>. If probe port is not set then this field is
blank.
enabled
shutdown
Interface Config
202-10102-01, May 2005
Switching Commands