Set Gmrp Interfacemode All; No Set Gmrp Interfacemode All; Show Gmrp Configuration - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

set gmrp interfacemode all

This command enables GARP Multicast Registration Protocol on all interfaces. If an interface
which has GARP enabled is enabled for routing or is enlisted as a member of a port-channel
(LAG), GARP functionality will be disabled on that interface. GARP functionality will
subsequently be re-enabled if routing is disabled and port-channel (LAG) membership is removed
from an interface that has GARP enabled.
Default
Format
Mode

no set gmrp interfacemode all

This command disables GARP Multicast Registration Protocol on a selected interface.
Format
Mode

show gmrp configuration

This command displays Generic Attributes Registration Protocol (GARP) information for one or
all interfaces.
Format
Mode
Interface
Join Timer
Leave Timer
Switching Commands
disabled
set gmrp interfacemode all
Global Config
no set gmrp interfacemode all
Global Config
show gmrp configuration {<slot/port> | all}
Privileged EXEC and User EXEC
This displays the slot/port of the interface that this row in the table describes.
Specifies the interval between the transmission of GARP PDUs registering (or
re-registering) membership for an attribute. Current attributes are a VLAN or
multicast group. There is an instance of this timer on a per-Port, per-GARP par-
ticipant basis. Permissible values are 10 to 100 centiseconds (0.1 to 1.0 sec-
onds). The factory default is 20 centiseconds (0.2 seconds). The finest
granularity of specification is 1 centisecond (0.01 seconds).
Specifies the period of time to wait after receiving an unregister request for an
attribute before deleting the attribute. Current attributes are a VLAN or multi-
cast group. This may be considered a buffer time for another station to assert
registration for the same attribute in order to maintain uninterrupted service.
There is an instance of this timer on a per-Port, per-GARP participant basis. Per-
missible values are 20 to 600 centiseconds (0.2 to 6.0 seconds). The factory
default is 60 centiseconds (0.6 seconds). The finest granularity of specification
is 1 centisecond (0.01 seconds).
202-10102-01, May 2005
8-107