NETGEAR ProSafe GSM7248 User Manual page 244

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
If the Policy Name is specified the following fields are displayed:
Policy Name
Type
The following information is repeated for each class associated with this policy (only those policy attributes
actually configured are displayed):
Assign Queue
Class Name
Committed Burst Size (KB)
Committed Rate (Kbps)
Conform Action
Conform COS
Conform DSCP Value
Conform IP Precedence Value
Drop
Mark CoS
Mark IP DSCP
Mark IP Precedence
Non-Conform Action
10-26
The name of this policy.
The policy type (Only inbound policy definitions are supported for this
platform.)
Directs traffic stream to the specified QoS queue. This allows a traffic
classifier to specify which one of the supported hardware queues are
used for handling packets belonging to the class.
The name of this class.
This field displays the committed burst size, used in simple polic-
ing.
This field displays the committed rate, used in simple policing,
The current setting for the action taken on a packet considered to con-
form to the policing parameters. This is not displayed if policing is not
in use for the class under this policy.
This field shows the CoS mark value if the conform action is set-cos-
transmit.
This field shows the DSCP mark value if the conform action is set-dscp-
transmit.
This field shows the IP Precedence mark value if the conform
action is set-prec-transmit.
Drop a packet upon arrival. This is useful for emulating access control
list operation using DiffServ, especially when DiffServ and ACL cannot
co-exist on the same interface.
Denotes the class of service value that is set in the 802.1p header of
inbound packets. This is not displayed if the mark cos was not specified.
Denotes the mark/re-mark value used as the DSCP for traffic matching
this class. This is not displayed if mark ip description is not specified.
Denotes the mark/re-mark value used as the IP Precedence for traffic
matching this class. This is not displayed if mark ip precedence is not
specified.
The current setting for the action taken on a packet considered to not
conform to the policing parameters. This is not displayed if policing not
in use for the class under this policy.
202-10102-01, May 2005
Quality of Service (QoS) Commands