Access-List - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

access-list

This command creates an IP Access Control List (ACL) that is identified by the parameter
<
accesslistnumber>.
The IP ACL number (<
<
accesslistnumber>
range 100 to 199 is for an IP extended ACL.
The IP ACL rule is specified with either a permit or deny action.
The protocol to filter for an IP ACL rule is specified by giving the protocol to be used like
icmp,igmp,ip,tcp,udp.
The command specifies a source ipaddress and source mask for match condition of the IP ACL
rule specified by the srcip and srcmask parameters.
The source layer 4 port match condition for the IP ACL rule is specified by the port value
parameter. The range of values is from 0 to 65535.
The < parameter uses a single keyword notation and currently has the values of
portvalue>
domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp
values translates into its equivalent port number, which is used as both the start and end of a port
range.
The command specifies a destination ipaddress and destination mask for match condition of the IP
ACL rule specified by the dstip and dstmask parameters.
The command specifies the TOS for an IP ACL rule depending on a match of precedence or DSCP
values using the parameters dscp,
The command specifies the assign-queue which is the queue identifier to which packets matching
this rule are assigned.
The command specifies the redirect interface which is the slot/port to which packets matching this
rule are forwarded.
Default
(IP Standard ACL)
Format
Mode
10-6
accesslistnumber>)
range 1 to 99 is for an IP standard ACL and the <
, tos, tosmask.
precedence
none
access-list <1-99> {deny | permit} <srcip> <srcmask>
Global Config
202-10102-01, May 2005
is an integer from 1 to 199. The
Quality of Service (QoS) Commands
accesslistnumber>
, and . Each of these
www