Show Loginsession; Show Users - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Mode

show loginsession

This command displays current telnet and serial port connections to the switch.
Format
Mode
ID
User Name
Connection From
Idle Time
Session Time

show users

This command displays the configured user names and their settings. This command is only
available for users with Read/Write privileges.
available on the system.
Format
Mode
User Name
Access Mode
SNMPv3 Access Mode
8-78
Privileged EXEC
show loginsession
Privileged EXEC
Login Session ID
The name the user will use to login using the serial port or Telnet. A
new user may be added to the switch by entering a name in a blank
entry. The user name may be up to 8 characters, and is not case sensi-
tive. Two users are included as the factory default, 'admin' and 'guest'.
IP address of the telnet client machine or EIA-232 for the serial port
connection.
Time this session has been idle.
Total time this session has been connected.
The SNMPv3 fields will only be displayed if SNMP is
show users
Privileged EXEC
The name the user will use to login using the serial port, Telnet or Web.
A new user may be added to the switch by entering a name in a blank
entry. The user name may be up to eight characters, and is not case sen-
sitive. Two users are included as the factory default, 'admin' and 'guest'
Shows whether the operator is able to change parameters on the switch
(Read/Write) or is only able to view them (Read Only). As a factory
default, the 'admin' user has Read/Write access and the 'guest' has
Read Only access. There can only be one Read/Write user and up to five
Read Only users.
This field displays the SNMPv3 Access Mode. If the value is set to
the SNMPv3 user will be able to set and retrieve parame-
ReadWrite,
202-10102-01, May 2005
Switching Commands