No Netbios-Node-Type; Next-Server; No Next-Server; Option - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
• h-node—Hybrid (recommended)
Default
Format
Mode

no netbios-node-type

This command removes the NetBIOS node Type.
Format
Mode

next-server

This command configures the next server in the boot process of a DHCP client.
Address is the IP address of the next server in the boot process, which is typically a Trivial File
Transfer Protocol (TFTP) server.
Default
Format
Mode

no next-server

This command removes the boot server list.
Format
Mode

option

The command configures DHCP Server options.
string specifies an NVT ASCII character string. ASCII character strings that contain white space
must be delimited by quotation marks. Hex string specifies hexadecimal data. in hexadecimal
character strings is two hexadecimal digits—each byte can be separated by a period, colon, or
white space.
8-90
none
netbios-node-type <type>
DHCP Pool Config
no netbios-node-type
DHCP Pool Config
If the next-server command is not used to configure a boot server list, the DHCP
Server uses inbound interface helper addresses as boot servers.
next-server <address>
DHCP Pool Config
no next-server
DHCP Pool Config
Code
202-10102-01, May 2005
specifies the DHCP option code. Ascii
Switching Commands