Classofservice Ip-Precedence-Mapping; Classofservice Trust; No Classofservice Trust; Cos-Queue Min-Bandwidth - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

classofservice ip-precedence-mapping

This command maps an IP precedence value to an internal traffic class. The ipprecedence and
trafficclass can both range from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format
Modes

classofservice trust

This command sets the class of service trust mode of an interface. The mode can be set to trust one
of the Dot1p (802.1p), IP Precedence, or IP DSCP packet markings.
Format
Mode

no classofservice trust

This command sets the interface mode to untrusted.
Format
Modes

cos-queue min-bandwidth

This command specifies the minimum transmission bandwidth guarantee for each interface queue.
The total number of queues supported per interface is platform specific. A value from 0-100
(percentage of link rate) must be specified for each supported queue, with 0 indicating no
guaranteed minimum bandwidth. The sum of all values entered must not exceed 100.
Format
Modes
10-30
classofservice ip-precedence-mapping <ipprecedence>
<trafficclass>
Global Config
Interface Config
classofservice trust <dot1p/ip-precedence>
Global Config
Interface Config
no classofservice trust
Global Config
Interface Config
cos-queue min-bandwidth <bw-0> <bw-1> ... <bw-n>
Global Config
Interface Config
202-10102-01, May 2005
Quality of Service (QoS) Commands