Table of Contents
Advertisement
Ordering information
Contents of this chapter
This chapter lists the types and ordering codes of the unit components.
You can find the kit-specific assembly drawings, step-by-step instructions and detailed
kit information on the Internet. Go to
https://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content. If necessary,
contact your local ABB representative.
Note:
•
This chapter only lists the installation accessories available from ABB. All other
parts must be sourced from a third party (such as Rittal) by the system integrator.
For a listing, refer to the kit-specific installation instructions available at
https://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content. For
access, contact your local ABB representative.
•
Parts that are labeled suitable for generic enclosures are not designed for any
specific enclosure system. These parts are intended as a basis for further
engineering, and may require additional parts to be fully usable.
Installation accessories designed for generic enclosures are in fact designed for
an inside width of 50 mm less than the nominal width of the enclosure. For
example, a mechanical kit intended for 800 mm wide generic enclosure is designed
for an inside width of 750 mm, and will not fit a 800 mm wide Rittal VX25 enclosure.
Kit code key
The kit codes shown in this chapter break down as follows.
The format of the kit code is x-w-s-yyy(-VX), for example, L-6-8-401 where:
•
x = cooling method
Ordering information 93
9
Advertisement
Table of Contents
