Table of Contents
Advertisement
Replacing AT-SBxPWRSYS1-80 DC Power Supplies
To replace an AT-SBxPWRSYS1-80 DC Power Supply, perform the
following procedure:
1. Turn off the circuit breaker to the AT-SBxPWRSYS1-80 DC Power
Supply.
2. Turn off the On/Off switch on the front panel of the power supply. Refer
to Figure 44 on page 96.
3. Use a #2 screwdriver to loosen the screw on the locking handle. Refer
to Figure 105.
Note
Do not lift the locking handle yet.
Figure 105. Loosening the Screw on the Locking Handle
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
181
Advertisement
Table of Contents
