Replacing Pwr600 Dc Power Supplies; Figure 147: Loosening The Screw For The Panel - Allied Telesis x950 Series Installation Manual

Chapter 14: Replacing Modules

Replacing PWR600 DC Power Supplies

248
This section contains the procedure for removing or replacing PWR600
DC Power Supplies.
Note
Allied Telesis recommends saving a backup copy of the
configuration file in the switch before removing or replacing power
supplies. For instructions, refer to the Software Reference for x950
Switches.
To remove DC power supplies from the switch, perform the following
procedure:
1. Power off the DC power supply.
2. Remove the ground wire from the ground point at the installation site.
3. Loose the screw for the connector panel with a Phillips-head
screwdriver. Refer to Figure 147.
Figure 147. Loosening the Screw for the Panel
4. Press the panel to the right to access the connecting screws as shown
in Figure 148 on page 249.