Operating Your St9420C; Choosing The Operating Mode (For Heating And/Or Hot Water); Overriding The Operation Without Changing The Programmes - Honeywell Home ST9420C User Manual

OPERATING YOUR ST9420C

Choosing the Operating Mode
The operating mode may only be changed when the slider is set to the RUN position.
The symbol is displayed during a programmed heating on period, and a
symbol is displayed during a programmed hot water on period. A green INDICATOR
LAMP shows when the heating or hot water is switched ON.
Two MODE buttons are provided to select the Operating Mode and therefore how the
heating and hot water are controlled.
Heating has four possible Operating Modes; these are OFF, AUTO, ONCE, CONT.
Pressing the heating MODE button scrolls round these modes in sequence, and the
display indicates which mode is currently active.
The heating will remain OFF.
•
AUTO (Automatic) mode
The heating will be switched ON and OFF according to the heating programme.
• ONCE mode
The heating will come ON at the first programmed ON time, and go OFF at the
last programmed OFF time.
• CONT (Continuous) mode
The heating will remain ON continuously.
The hot water MODE button operates in the same way as described above for the
heating MODE button.

Overriding the Operation Without Changing the Programmes

In AUTO and ONCE operating modes, the OVERRIDE buttons switch the heating or
hot water ON or OFF without altering the programme.
When the or
the heating or hot water OFF until the next programmed ON time.
If the or
the heating or hot water ON until the next programmed OFF time.
The LoT™ Display will provide you with information about the override.
12
symbol is displayed, pressing the OVERRIDE button switches
symbol is not displayed, pressing the OVERRIDE button switches
(for Heating and/or Hot Water)