Exhaust - Spark Arrestor - Polaris 2013 RANGER RZR S Service Manual

MAINTENANCE

Exhaust - Spark Arrestor

WARNING
Do not clean spark arrestor immediately after the
engine has been run, as the exhaust system
becomes very hot. Serious burns could result from
contact with the exhaust components. Allow
components to cool sufficiently before proceeding.
Wear eye protection and gloves.
Never run the engine in an enclosed area. Exhaust
contains poisonous carbon monoxide gas that can
cause loss of consciousness or death in a very
short time.
Periodically clean spark arrestor to remove accumulated
carbon (see "Periodic Maintenance Chart").
1. Remove the retaining screw, nut and spark arrestor
from the end of the silencer.
2. Use a non-synthetic brush to clean the arrestor
screen. A synthetic brush may melt if components are
warm.
3. Inspect the screen for wear and damage. Replace if
needed.
4. Reinstall the arrestor and torque the screw to
specification.
Silencer
Spark Arrestor Screw:
40 in-lbs (4.5 Nm)
2.18
Screen
Arrestor
Retaining
Screw
Nut
= T
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.