Reverse Warning Buzzer Limit Switch Installation; Front Differential Limit Switch - Club Car Carryall 1500 Maintenance And Service Manual

ELECTRICAL COMPONENTS: DIESEL VEHICLES
2141
Figure 14-8 Reverse Warning Buzzer Limit Switch
Adjustment Slot

REVERSE WARNING BUZZER LIMIT SWITCH INSTALLATION

1. Install the reverse warning buzzer limit switch in the reverse order of removal.
2. Place the Forward/Reverse handle in the REVERSE position.
3. Tighten the limit switch mounting screws so that they are snug, but the limit switch can still be rotated in the
adjustment slot (Figure 14-8, Page 14-13).
4. Rotate the limit switch so that the lobe on the Forward/Reverse handle activates the limit switch as shown
(Figure 14-9, Page 14-13).
5. Hold the limit switch in position and tighten the mounting screws and nuts to 4 in-lb (0.5 N·m). See following
CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, the limit switch could become
damaged.
6. Place the Forward/Reverse handle in NEUTRAL and then back to REVERSE to ensure that the limit switch
lever is being properly activated.
7. Connect the 18-gauge red and 18-gauge red/white wires to the limit switch.
8. Lower and secure the hood.
9. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
10. Turn the key switch to the ON position. With the Forward/Reverse handle in REVERSE, the buzzer should sound.

FRONT DIFFERENTIAL LIMIT SWITCH

See General Warnings, Section 1, Page 1-2.
2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Front Differential Limit Switch
2142
Figure 14-9 Reverse Warning Buzzer Limit Switch
(Properly Adjusted)
14
Page 14-13