Club Car Carryall 1500 Maintenance And Service Manual page 190

12
Test Procedures
2106
Figure 12-7 Frame Ground
TEST PROCEDURE 4 – Key Switch (Starter Circuit)
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Remove the key switch. See Key Switch Removal on page 14-7.
3. Ensure that the key switch connector is connected correctly and is tight. If it is not, repair or replace as necessary.
4. Set the multimeter to 200 ohms.
5. Check the B and A key switch terminals.
5.1. Use alligator clips to connect the multimeter probes between the B and A terminals. With the key switch in
the START position, the multimeter should indicate continuity (Figure 12-9, Page 12-14). If the multimeter
does not indicate continuity, the key switch has failed and should be replaced. See Key Switch Removal
on page 14-7.
5.2. If the multimeter indicates continuity between the B and A terminals with the key in any position other than
START, the key switch has failed and should be replaced. See Key Switch Removal on page 14-7.
REAR VIEW
B
S
A
I
Continuity Diagram A
Key Position
PRE-
HEAT
2108
Figure 12-9 Key Switch Terminals and Continuity Diagram
6. Check the B and I terminals.
Page 12-14 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
FRONT VIEW
B B B
S S S
A A
I I I
O I
OFF ON
TROUBLESHOOTING AND ELECTRICAL
2107
Figure 12-8 Engine Ground (Under Starter)
B
S
A
I
START
SYSTEM: DIESEL VEHICLES