Club Car Carryall 1500 Maintenance And Service Manual page 348

17
Transmission
2567
Figure 17-13 Forward/Reverse Cable Connections At Shifter Handle and Transmission
Forward/Reverse Shifter Cable Installation
1. Secure a new cable to the transmission end of the nylon cord at the dash frame. Pull and route the cable from the
dash frame to the transmission. See following NOTE.
NOTE: If a nylon cord was not used to remove the cable, carefully feed the cable from behind the dash frame down
between the splash guard and frame, under the vehicle body, and up to the transmission.
Use care during cable installation and avoid bending the rigid tubular ends of the cable assembly.
2. Attach cable end to Forward/Reverse shifter handle in the dash (Figure 17-13, Page 17-10). Secure with clip.
3. Loosen the flanged nut farthest from the handle end as far away from the handle end as the thread will allow.
4. Advance the front flanged nut away from the rear nut. Allow enough room to install the cable and two flanged nuts
on the shifter bracket on the dash frame.
5. Adjust the shifter cable. See Forward/Reverse Shifter Cable Adjustment on page 17-10.
Forward/Reverse Shifter Cable Adjustment
1. Verify that the transmission shifter arm is in the NEUTRAL position.
2. Loosen the flanged nuts from the cable bracket that is below and forward of the transmission shifter arm (Figure
17-13, Page 17-10).
3. Attach cable end to transmission shifter arm (Figure 17-13, Page 17-10). Secure with clip.
4. Hold the shifter arm on the transmission in the NEUTRAL position and align the shifter handle with the neutral
position mark on the instrument panel. See following NOTE.
NOTE: This procedure is best performed with the help of an assistant.
5. Advance the front flanged nut, closest to the transmission shifter arm, up against the front side of the cable bracket.
Page 17-10 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
DRIVETRAIN COMPONENTS