Seat; Seat Removal; Seat Adjustment - Club Car Carryall 1500 Maintenance And Service Manual

BODY AND TRIM
8. Tighten all hardware to 33 ft-lb (45 N·m). See following WARNING and NOTE.
NOTE: If any ROPS joints remain loose, apply additional torque up to 40 ft-lb (54 N·m).
WARNING
• Exceeding the maximum torque value could result in damage to the ROPS tubing and stripped threads
on the hardware.
• Ensure that the ROPS is properly installed before operating the vehicle.

SEAT

See General Warnings, Section 1, Page 1-2.

SEAT REMOVAL

1. Bucket seats
1.1. Lift the seat back up and forward to raise it.
1.2. Remove the seat by lifting the front edge hinges from the vehicle frame hinge slots.
2. Bench seat
2.1. Lift the seat bottom up and forward to raise it.
2.2. Remove the seat by lifting the front edge hinges from the vehicle frame hinge slots.

SEAT ADJUSTMENT

1. Stationary driver and passenger bucket seats
1.1. Remove the seat from the vehicle.
1.2. Remove the four bolts and washers from the bottom of the seat mounting plate.
1.3. Align the mounting plate holes with the holes in the seat to achieve the desired seat position.
1.4. Install the washers and bolts, and tighten the hardware to 80 in-lb (9.0 N·m).
1.5. Install the seat. See following WARNING.
WARNING
• Ensure that the seat hinges and latch are securely engaged before operating vehicle.
2. Track-mounted driver seat
2.1. Sit in seat, grasp seat adjustment handle under seat bottom and slide seat to desired position. See
preceding WARNING.
2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
4
Seat
Page 4-9