Bed Lift Circuit Breaker Installation; Light Switch; Testing The Light Switch; Light Switch Removal - Club Car Carryall 1500 Maintenance And Service Manual

ELECTRICAL COMPONENTS: GASOLINE
VEHICLES

BED LIFT CIRCUIT BREAKER INSTALLATION

Install the circuit breaker in the reverse order of removal.

LIGHT SWITCH

See General Warnings, Section 1, Page 1-2.

TESTING THE LIGHT SWITCH

See Test Procedure 33 – Light Switch on page 11-35.

LIGHT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Raise the hood.
3. Press the upper and lower retaining tabs and push the light switch (11) out of the instrument panel (Figure
13-6, Page 13-7).
4. Disconnect the wire harness from the light switch.

LIGHT SWITCH INSTALLATION

1. Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2. Push the light switch into the instrument panel until fully seated.
3. Lower and secure the hood.
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.

FUSE

See General Warnings, Section 1, Page 1-2.
WARNING
• Failure to use properly rated fuse can result in a fire hazard.
2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
13
Light Switch
Page 13-11