Club Car Carryall 1500 Maintenance And Service Manual page 127

PERIODIC MAINTENANCE
210
Figure 10-11 Replace Engine Oil Filter – Kawasaki
Gasoline Vehicles
Engine Oil Filter Change
1. Drain the engine oil. See Engine Oil Draining on page 10-12.
2. Place the oil drain pan under the engine oil filter (2) (Figure 10-10 or Figure 10-11).
3. Remove the engine oil filter. Turn it counterclockwise and drain the residual oil in the filter port and filter into
the oil drain pan. See following NOTE.
NOTE: An oil drip guard can be used to prevent excess oil from dripping onto the engine base plate (Figure 10-12).
Use an empty quart (one liter) container and cut the bottom off at an angle, then slide the open area of the
container up and under the oil filter before removal. Position the port of the plastic container so oil will be
directed into the oil pan. A drip guard can be made by folding a piece of cardboard, thin metal, or plastic under
the oil filter, forming a channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
26
Figure 10-12 Remove Engine Oil Filter
4. Use a clean rag to wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
5. Coat filter gasket with clean engine oil (Figure 10-13, Page 10-13).
6. Install the new oil filter (gas: CC P/N 103887901) (diesel: CC P/N 102703301). See following NOTE.
NOTE: Only use oil filters designed for this engine.
7. Hand tighten 2/3 to 3/4 turn after the filter gasket contacts the mounting surface.
2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
27
Figure 10-13 Coat Rubber Seal
10
Engine Oil
Page 10-13