Club Car Carryall 1500 Maintenance And Service Manual page 366

19
Attachment Interface
1. Lower the attachment arm to the ground and tilt the attachment interface forward (Figure 19-5, Page 19-3).
2. Stop the engine, put the Forward/Reverse Handle in NEUTRAL, engage the park brake, unfasten your seat
belt, and exit the vehicle.
3. Remove the retaining ring (1) and pin (2) from the attachment interface cylinder rod end, and keep the retaining
ring and pin for later use in this procedure (Figure 19-6, Page 19-3).
4. Remove the retaining ring (1) and the pin (2) from the attachment arm cylinder rod end (Figure 19-7, Page 19-4).
2226
Figure 19-7 Remove Attachment Cylinder Retaining Pin
5. Turn the start key to the ON position but DO NOT start the engine.
6. Retract the attachment arm cylinder fully by moving the joystick (1) back (Figure 19-8, Page 19-4).
7. Retract the attachment interface cylinder fully by moving the joystick (1) to the left.
8. Turn the start key to the OFF position.
9. Rotate the attachment arm cylinder (1) vertically against the mount (2) (Figure 19-9, Page 19-5).
10. Install the existing pin (3) and retaining ring to secure the cylinder to the mount.
11. Rotate the attachment interface cylinder (5) upward against the vehicle and snap it into place (8).
12. Install the existing pin (6) and retaining ring (7) in the locking hole on the mounting plate.
13. Remove the two retaining rings (1) and pins (2) from the attachment arms and mounting plate (Figure 19-10,
Page 19-5).
14. Lower the attachment arm to the ground.
15. To store, install pins (1) into the attachment arm holes (both sides) and secure with the retaining pins (2) (Figure
19-11, Page 19-5).
Page 19-4 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
HYDRAULIC ATTACHMENT SYSTEM
256
Figure 19-8 Joystick