Front Coil-Over Shock Absorber Removal - Club Car Carryall 1500 Maintenance And Service Manual

7
Front Suspension Components
4. Install a new bolt, washer, and new flanged locknut. Tighten the hardware to 110 ft-lb (148 N·m), applying
torque to the bolt side.
5. Repeat steps 1 through 4 for the remaining side if necessary.
6. Align the front wheels. See Wheel Alignment on page 7-10.

FRONT COIL-OVER SHOCK ABSORBER REMOVAL

1. Lift and support the front of vehicle and remove the wheels. See Lifting The Vehicle on page 3-7.
2. Place a floor jack under the lower A-arm at the lower ball joint, and raise the jack just enough to allow the A-arm
assembly to rest on the jack.
3. Remove the flange-head bolt. Separate the bottom of the shock absorber from the top A-arm assembly (Figure
7-39, Page 7-20).
4. Remove the bolt and flanged locknut from the top of the shock mount. Remove the shock absorber.
5. Repeat steps for the remaining shock absorber.
1890
Figure 7-38 Jack Stand Placement
2073
Figure 7-39 Front Shock Bottom Mount
Page 7-20 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
STEERING AND FRONT SUSPENSION
2074
Figure 7-40 Front Shock Top Mount