Reverse Warning Buzzer Installation; Reverse Warning Buzzer Limit Switch (If Equipped); Testing The Reverse Warning Buzzer Limit Switch; Reverse Warning Buzzer Limit Switch Removal - Club Car Carryall 1500 Maintenance And Service Manual

14

Reverse Warning Buzzer Limit Switch (If Equipped)

2098
Figure 14-7 Reverse Warning Buzzer and Limit Switch

REVERSE WARNING BUZZER INSTALLATION

1. Install the reverse warning buzzer and secure it with two plastic rivets.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Lower and secure the hood.
5. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
REVERSE WARNING BUZZER LIMIT SWITCH (IF EQUIPPED)
See General Warnings, Section 1, Page 1-2.

TESTING THE REVERSE WARNING BUZZER LIMIT SWITCH

See Test Procedure 25 – Reverse Warning Buzzer Limit Switch (If Equipped) on page 12-33.

REVERSE WARNING BUZZER LIMIT SWITCH REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Raise the hood.
3. Disconnect the wires from the reverse warning buzzer limit switch (Figure 14-7, Page 14-12).
4. Remove the screws, nuts, washers, and lockwashers that secure the limit switch.
5. Remove the limit switch.
Page 14-12 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
ELECTRICAL COMPONENTS: DIESEL VEHICLES