Club Car Carryall 1500 Maintenance And Service Manual page 150

11
Test Procedures
2082
Figure 11-7 Frame Ground
TEST PROCEDURE 4 – Key Switch (ON Position)
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Ensure that the key switch connector is connected correctly and is tight. If it is not, repair or replace as necessary.
3. Remove the key switch. See Key Switch Removal on page 13-8.
4. Set the multimeter to 200 ohms.
5. Turn the key switch ON. Place the red (+) probe of the multimeter on the (B) terminal and the black (–) probe
on the (L) terminal of the key switch. The reading should indicate continuity. If the reading does not indicate
continuity, replace the key switch (Figure 11-9, Page 11-14). See Key Switch Removal on page 13-8.
REAR VIEW
Continuity
Diagram
O
Key Position
OFF
2356
Figure 11-9 Key Switch Terminals and Continuity Diagram
TEST PROCEDURE 5 – Key Switch (Starter Circuit)
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
Page 11-14 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
FRONT VIEW
I
ON
START
TROUBLESHOOTING AND ELECTRICAL
SYSTEM: GASOLINE VEHICLES
2083
Figure 11-8 Engine Ground to Frame