Testing The Front Differential Limit Switch; Front Differential Limit Switch Removal; Front Differential Limit Switch Installation - Club Car Carryall 1500 Maintenance And Service Manual

ELECTRICAL COMPONENTS: GASOLINE
VEHICLES

TESTING THE FRONT DIFFERENTIAL LIMIT SWITCH

See Test Procedure 17 – Front Differential Limit Switch on page 11-25.

FRONT DIFFERENTIAL LIMIT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Locate front differential limit switch above accelerator pedal.
3. Disconnect wire leads of switch (1) from wire harness (Figure 13-10, Page 13-15).
4. Remove the nuts (2) and screws (3) that secure the switch (1) and remove the switch.
2496
Figure 13-10 Front Differential Limit Switch Removal

FRONT DIFFERENTIAL LIMIT SWITCH INSTALLATION

1. Install the front differential limit switch (1) in the reverse order of removal and tighten the nuts (2) to 4 in-lb (0.5
N·m) (Figure 13-10, Page 13-15). See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, the switch could become damaged.
2. Move the accelerator pedal back and forth to ensure that the switch lever is being properly activated.
3. Connect wire leads of switch to wire harness.
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
1
2
2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Front Differential Limit Switch
13
Page 13-15