Fuse Installation; Reverse Warning Buzzer (If Equipped); Testing The Reverse Warning Buzzer; Reverse Warning Buzzer Removal - Club Car Carryall 1500 Maintenance And Service Manual

ELECTRICAL COMPONENTS: DIESEL VEHICLES
3. Remove the fuse from the fuse block.

FUSE INSTALLATION

1. Install the fuse. See following WARNING.
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before installing a
new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is used, damage to the
vehicle electrical system may occur.
2. Install the electrical component cover.
3. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.

REVERSE WARNING BUZZER (IF EQUIPPED)

See General Warnings, Section 1, Page 1-2.

TESTING THE REVERSE WARNING BUZZER

See Test Procedure 26 – Reverse Warning Buzzer (If Equipped) on page 12-33.

REVERSE WARNING BUZZER REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Raise the hood.
3. Remove the plastic rivets securing the reverse warning buzzer and remove the reverse warning buzzer (Figure
14-7, Page 14-12).
2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
Reverse Warning Buzzer (If Equipped)
14
Page 14-11