Rear Shock Installation - Club Car Carryall 1500 Maintenance And Service Manual

9
Rear Coil-Over Shock Absorber
1. Location of brake hose with rubber grommet
2494
Figure 9-1 Rear Shock Absorber Removal

REAR SHOCK INSTALLATION

Ensure that the adjustment position of the coil spring on the new shock absorber is the same as the previous shock
absorber. Use the adjustment position on the coil spring from the previous shock absorbers as a reference. See
following NOTE.
NOTE: When shock absorbers are installed, ensure both shock absorbers have identical part numbers.
1. Installation is the reverse of removal.
2. Tighten the upper and lower hardware, using new lock nuts, to 73 ft-lb (99 N·m).
3. If detached during removal, secure the brake hose and rubber grommet in the lower shock bracket.
4. Install wheel and lower vehicle. See Wheel Installation on page 8-2.
5. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles on page 1-4.
Page 9-2 2015 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
1
REAR SUSPENSION