Reverse Buzzer Limit Switch; Testing The Reverse Buzzer Limit Switch; Reverse Buzzer Limit Switch Removal; Reverse Buzzer Limit Switch Installation - Club Car Precedent 2014 Maintenance And Service Manual

20

Reverse Buzzer Limit Switch

REVERSE BUZZER LIMIT SWITCH
See General Warnings on page 1-2.

TESTING THE REVERSE BUZZER LIMIT SWITCH

See Test Procedure 17 – Reverse Buzzer Limit Switch on page 19-29.

REVERSE BUZZER LIMIT SWITCH REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
2. Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/Reverse
assembly (Figure 20-19, Page 20-17).
3. Remove the nuts (2) and washers (6) from the neutral lockout limit switch (5) and slide the neutral lockout limit
switch off of the screws. Do not disconnect the wires.
4. Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit switch off
the screws.

REVERSE BUZZER LIMIT SWITCH INSTALLATION

1. Install the reverse buzzer limit switch (4), and then install two spacers (9) against the limit switch (Figure 20-19,
Page 20-17).
2. Install the neutral lockout limit switch (5) with two washers (6) and two nuts (2). Tighten to 5 in·lb (0.6 N·m).
See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be damaged.
3. Place the Forward/Reverse handle in REVERSE and make sure that both switches actuate.
4. Connect the orange wire to the common (COM) terminal and the red/white wire to the normally open (NO)
terminal of the reverse buzzer limit switch (4) (Figure 20-19, Page 20-17).
5. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 1-4.
6. Shift the Forward/Reverse handle to the REVERSE position. The buzzer should sound.
Page 20-20 2014 Precedent ® Golf Car Maintenance and Service Manual
ELECTRICAL COMPONENTS (GASO-
LINE VEHICLE)