Start Labeling Operation; Stop Labeling Operation - Weber Geset 141 Original User Manual

Chapter 8 Operation

Start labeling operation

Requirements
¥
Labeling station is turned off.
¥
Labeling station is connected to power.
¥
Labeling station was adjusted correctly to the product (see chapter "Adjustment
and initial operation" from page 45).
Instructions
Please turn on the labeling system for operation as follows.
Step
1
2
3
4
5

Stop labeling operation

Requirements
¥
Labeling station is in labeling operation (s.a.)
Instructions
Please stop labeling operation as follows.
Step
1
2
3
4
Version: 30.01.15
Procedure
Turn on the power supply of the labeling station.
Turn on the labeler (s. section above). Then the applicator changes to idle
mode and firstly following text message appears in display:
ALPHA COMPACT.x
STAND-BY
X
stands for the version number of the Firmware installed in the controller.
In this condition the applicator does arrange any activities. When pushing
any button the applicator changes to its „standard" operational state.
Push the [Start]-button to enable labeling operation. Presumed that the start
procedure of the labeler is terminated, the labeler has been calibrated on the
labels and no further failures are available.
Put a product into the 3-roll system.
Start a labeling cycle by pushing the foot switch.
Procedure
Turn off the labeler.
Turn off the labeling station.
Remove manual or faulty applied labels if applicable.
Observe the remarks „
Page 54 of 97
Putting the system out of service
40020664 Geset 141
0000
page 55)
" (s.
GB