Table of Contents
Advertisement
Chapter 10 Troubleshooting
Problem
Improper label stop-position (to
peeler bar)
Labels run without stop tho-
rugh resp. the positioning of
label at peeler bar is irregular.
The desired rate of application
cannot be reached with the
labeler...
Machine functions occur at
random without being initiated.
Version: 30.01.15
Possible cause
Wrong parameterization.
High label speed or high
Start-/stop-ramps (> G2) at
low value for „label postion".
Label sensor is dirty.
Web brake is adjusted too
tightly.
When the label stop is scan-
ned mechanically:
Label is not detected cor-
rectly.
Label length is more than
300mm.
Transmitter and receiver of
the label-stop-light barrier of
the applicator are not placed
exactly above each other
(mechanically damaged).
LED at receiver of label-stop-
light-barrier lights permanent-
ly.
Wrong settings of the labeler,
system cycle times are too
long.
Loose wiring connections.
Page 93 of 97
40020664 Geset 141
Solution
Check the configuration para-
meter for ramp values. Observe
the influence of label length to
feed speed or inquire Service-
Technician by Hotline (s. page
7).
Change of position of label
sensor to achieve a higher va-
lue for label position.
Reduction of start-/stop-ramp
values or label speed.
Clean label sensor.
Check adjustment.
Load label web again if appli-
cable or check position of the
label sensor.
Remove adhesive residues at
the scanning roll.
Adjust the label length in confi-
guration menu in parameter [01
Label Length] accordingly.
Adjust transmitter and receiver
or replace if applicable.
Check the sensitivity setting.
Inquire Service Technician at
Hotline (s. page 7).
Check all connections at la-
beler.
GB
Advertisement
Table of Contents
