Table of Contents
Advertisement
Chapter 6 Installation and initial startup
6.
Installation and initial startup
Safety instructions
Version: 30.01.15
Hazard from direct or indirect contact with voltage-
conducting parts.
DANGER TO LIFE!
When individuals touch parts that conduct electricity arising from
malfunctions can lead to death.
- Only electricians may work on the switch cabinet and electrical
equipment.
- Regularly check the electrical equipment of the labeler.
- Immediately take care of loose connections and damaged ca-
bles.
- Always keep the switch cabinet locked.
- Before working on electrical equipment, switch the miniature
circuit breaker to "0" position and secure it against being acci-
dentally turned on. If possible, disconnect the power.
Hazard from easily flammable label material.
FIRE HAZARD!
The ribbon and labels are easily flammable. Potential injury from
fire and smoke.
- Keep away from sources of ignition and open fire..
Hazard from rotating elements.
ENTANGLEMENT HAZARD!
Rotating elements at the labeler like label liner rewinder and label
feed are powered by motors.
- Do not grip in, at or between the moving parts.
Tripping hazard from connecting lines.
RISK OF INJURY!
Connecting lines for power, compressed air and computer and
signal lines can pose a tripping hazard, causing serious injury.
- Release the tension of connecting lines to the system and run
them so that they do not pose a hazard.
Danger of injury from corners and edges.
RISK OF INJURY!
Scrapes and cuts can result from sharp edges and pointed cor-
ners. Always keep the work area clean.
- Observe caution when working close to sharp edges and
pointed corners. Remove unnecessary objects.
- In case of doubt, wear protective gloves.
Page 29 of 97
40020664 Geset 141
GB
Advertisement
Table of Contents
