Table of Contents
Advertisement
Chapter 8 Operation
PROGRAMMING
The programming mode can be reached by pushing simultaneously the buttons [] and
[
] presumed the labeler is in stand-by-mode. The PROGRAMMING mode allows the
consideration of all 256 service parameters
A further simultanous pushing of the buttons [] and [
menu with 4 additional functions that concern the total configuration of the labeler.
For protection of the parameters, the programming mode is password protected.
Most of these parameters remain unchanged in their factory settings (shortly "default").
But few of them may need to be adapted to specific requirements (probably just once dur-
ing installation).
Programming-Address
The display shows in line 1 after "PROGRAMMING" a three digit number (e. g. "016").
Although the number for the currently selected parameter. In line 2 there is respectively
the value (resp. content) of the parameter.
PROGRAMMING
PARAMETER VALUE
Version: 30.01.15
Wrong parameters can lead to bugs and improper functions,
also possibly leading to mechanical damage.
This applies also in changes of reserved or undocumented pa-
rameters as well as entering values outside the valid ranges.
- The parameterization should only be edited by authorized and
trained personnel!
016
123
Page 83 of 97
40020664 Geset 141
] grants access to further sub-
GB
Advertisement
Table of Contents
