116 Extension Delay (Extension Delay); 117 Extension Time - Weber Geset 141 Original User Manual

Chapter 8 Operation

116 EXTENSION DELAY (EXTENSION DELAY)

This parameter enables the programming of a delay value between trigger signal and ac-
tual tamp movement. The delay starts with triggering (external or autom.). The EXTENS:
DELAY will be ignored, if the parameter APPLICATOR TRIGGER has the value "000".
(ref. page 76).
CONFIGURATION
EXTENS. DELAY

Press [Enter] to edit the configuration parameter.

Push the *buttons [] or [] to increase or reduce the parameter value. (unit =
value x 10ms, value "000" = no delay).

Press [Enter] to save the value.

Press [Start] or [Stop] to exit the parameter setting.

117 EXTENSION TIME

The „EXTENSION TIME" defines the time that passes from the beginning of the stroke
movement until the beginning of blow-action. You set the labeler in Blow-On mode via the
value "000". The label will be blown off directly without movement of the applicator.
The dimensioning of the adjusted time (unit = value x 10ms) should correspond to the ac-
tual time for the extension of the whole stroke. If the specified value is exceeded because
of another parameter configuration, the label will be blown off immediately onto the prod-
uct, unless the labeler waits of a trigger signal (e.g. "BLOW TRIGGER" or from the sensor
"variable stroke"). When using the option "variable stroke" normally the EXTENSION TIME
is set on a low value (e.g. "002") to continue with the variable range of the stroke after a
constant extension length.
CONFIGURATION
EXTENSION TIME

Press [Enter] to edit the configuration parameter.

Push the *buttons [] or [] to increase or reduce the parameter value. (unit =
value x 10ms, value "000" = Blow-On mode).

Press [Enter] to save the value.

Press [Start] or [Stop] to exit the parameter setting.
Version: 30.01.15
116
000
117
080
Page 77 of 97
40020664 Geset 141
GB