Table of Contents
Advertisement
Chapter 8 Operation
Putting the system out of service
The label material running around the deflection rollers is curved which can cause prob-
lems with the operation mode. This characteristic of the labels as well as the retained cur-
vature depend on the material which can vary significantly between the different print me-
dia. The ambient conditions such as high temperatures and humidity enhance this effect.
Remove critical label material before long breaks and after end of work from la-
beler!
Instructions
Please put the labeler out of service as follows.
Step
1
2
3
4
5
Version: 30.01.15
When turning off the system for several hours, the label web has
to be removed from the applicator to prevent failures at restart.
Procedure
Stop labeling operation (s. page 54)
Disconnect the power supply.
Protect the labeling station from dust with a cotton or linen cloth.
If the labeling station should be stored and/or transported, please observe
the remark for...
Transport
(page 25)
Storage conditions
Transport the labeling station like in chapter "Transport" to its storage place.
Page 55 of 97
(page 28)
40020664 Geset 141
GB
Advertisement
Table of Contents
