Table of Contents
Advertisement
Chapter 6 Installation and initial startup
Setting up the labeling system
Requirements
¥
The labeling system is unpacked and prepared (see the chapter: "Transport" on
page 25) near the labeling site in the area of the installation site.
¥
The base is solid, level and flat.
¥
The labeling system must be completely installed.
¥
The connections for the compressed air and electricity are close to the labeling
site (maximum distance of 1.5 m) as specified in the chapter: "Specifications" on
page 22).
Required equipment
¥
Flat wrench
¥
Spirit level
Instruction
Set a labeling system up as follows.
Step
1
2
Version: 30.01.15
Procedure
Move the labeling system to installation site. Move labelers without rolls
piece by piece diagonally. Consider all points for "Placing the labeling sys-
tem" on page 30.
Adjust the labeling system with an air lever horizontally.
Page 31 of 97
40020664 Geset 141
GB
Advertisement
Table of Contents
