Chapter 8 Operation
105 LABEL QUEUE
Herewith the number of labels between peeler bar and label sensor is adjusted manually.
Thus the labeler is able to compensate a missing label by feeding the gap to the next la-
bel. The calibration function determines this value automatically.
CONFIGURATION
LABEL QUEUE
Press [Enter] to edit the configuration parameter.
Press either [] or []to increase or reduce the value.
Press [Enter] to confirm the entry
Press [Start] or [Stop] to exit the parameter setting.
106 LABELS BURST(LABELS BURST)
Herewith the number of label application per start signal (trigger signal) is adjusted. If the
parameter is set on 000, 1 label per start signal will be applied.
CONFIGURATION
LABELS BURST
Press [Enter] to edit the configuration parameter.
Press either [] or []to increase or reduce the value.
Press [Enter] to confirm the entry
Press [Start] or [Stop] to exit the parameter setting.
Version: 30.01.15
105
002
106
001
Page 70 of 97
40020664 Geset 141
GB