Table of Contents
Advertisement
Chapter 7 Adjustment and initial operation
Adjust parallelism to product
The parallelism of the labeler (peeler plate) to the 3-roll system was adjusted optimally ex-
factory. If the labeling should however result in a spiralization" of the labels, i.e. label be-
ginning- and end are shifted to each other (s. Fig. 7-7), the parallelism of the labeler (pee-
ler plate) has to be corrected.
This adjustment requires experience and „intuition". It is advisable to mark the
front surfaces of the mounting plate with a marking line to be able to re-establish
the original position at any time.
Requirements
¥
One or more sample products.
¥
Labels are inserted correctly.
¥
3-roll system and product stop are adjusted correctly (s. from page 49).
¥
Machine is ready for labeling.
Instructions
Please adjust the parallelism to the labeler as follows.
Step
1
2
3
4
5
Version: 30.01.15
Procedure
Loosen both screws to the Alpha-mounting (s. Pos. 4 in Fig. 7-5).
Swing the labeler! Notice the rotating direction.
Hazard from actively controlled movements. Maintain a distance from moved
parts.
Arrange several sample labelings. If the result is satisfying, please go on
with step 5.
Check the label on the product, if the offset...
¥ Has increased, swing the labeler in opposite direction.
¥ Has decreased, swing the labeler in same direction on.
Please go on with step 3.
Lock this adjustment by fixing the screws.
Page 52 of 97
40020664 Geset 141
Fig. 7-7: Spiralization
GB
Advertisement
Table of Contents
