Chapter 8 Operation
Operator panel
No.
1
2
3
Turn on labeling operation
The automatic operation is used to label products. .
Requirements
¥
Labeling system is turned off.
¥
Material rolls at labeling system are loaded and threaded.
¥
Labeling system is connected to power.
¥
System was put into operation (see chapter „Installation and initial startup" on
page 29).
Instruction
Please turn on the labeling system for operation as follows
Step
1
2
3
4
5
Version: 30.07.14
Description
EMERGENCY STOP PUSHBUTTON
RED BUTTON AUTOMATIC OFF
GREEN ILLUMINATED BUTTON AUTOMATIC ON
Procedure
Turn on the main switch.
Risk of injury from crushing! Hazards from actively controlled movements.
Keep away from moving parts.
Push the [START] –button at labeler.
Push the [AUTOMATIC ON] –button at operator panel.
Add the products to the labeling system.
Remove the products from outfeed of the labeling system.
Page 44 of 57
40001136 Geset 125
Fig. 8-3: Operator elements
GB